The first step, through the film
To get the film, you need to confirm the winding direction of the film, find out the counterclockwise direction, and put it on the film rod to fix it. (Please turn off the power when wearing the film.) Pay attention to whether the front and rear fixing splints of the film are tightly bonded to the film. If it cannot be tightly bonded, use a utility knife to cut the inner side of the film tube at a bevel before putting it in. After wearing the film, stick the film firmly on the receiving paper tube with tape.

The second step, operation steps (panel operation instructions)
Turn on the power, turn on the power switch, the indicator light is on, set the thermostat to the predetermined temperature, and the green heating indicator light is on at this time. When the upper heating plate reaches the predetermined temperature, the red constant temperature indicator light is on (when the sealing machine is working, the electric heating device is constantly alternately in the state of heating and heat preservation, so the green and red indicator lights are also continuously displayed alternately, which is a normal phenomenon). Put the plastic cup into the lower mold slide, push the lower mold slide to a certain position by hand (if it is a fully automatic sealing machine or an automatic sealing machine, after putting the plastic cup, the lower mold slide will automatically enter), press down The handle of the sealing machine reaches the maximum stroke, hold the pressure for 1~2 seconds, then slowly raise the handle and push it to the original position. Pull out the slide plate of the lower mold, take out the plastic cup, put into the end-sealed plastic cup, and perform another cycle.

Cleaning and maintenance of can sealing machine
Regularly clean the surface of the machine table, the bottom plate and the slide plate of the lower mold, the groove, the inner pressure plate of the upper mold and the positioning rod (note: the power must be turned off and returned to normal temperature). Regularly add butter to the transmission parts such as the slide plate of the lower die, the pressure rod bearing, the eccentric wheel, the guide column, and the guide rail to ensure the performance of the machine. How to clean the toothed knife: first plug the two drain holes of the lower mold with cotton balls, pour boiling water into the groove of the lower mold until it is full, then push the sliding plate of the lower mold in place, press down the upper mold, press To the lowest point, let the knife soak for several minutes until it is clean, repeat several times.